I always wondered what was inside these neat 1980s radios. time to take one apart! 🧵
batteries go in here. looks like remnants of corrosion, hope it's not too damaged.
on the back there's a switch to select between local and distant (DX) stations. also a few screws.
wow it's really tightly packed! through-hole components and even some point to point wiring
it's strange seeing surface mount chips and point to point wiring on the same circuit board
the buttons on the front are taped in place 😂
this copper foil shield got corroded.
I cleaned up the corrosion and amazingly it works fine! you have to use it with headphones because the radio circuit uses them as the antenna.
despite all the point to point wiring, tape, and stuff like that, the build quality isn't bad for a consumer product. the screws go into these brass inserts instead of into fragile but cheap plastic bosses.
if you're curious about my cleaning method, corroded parts go into a vinegar bath for a few minutes, and then get cleaned with isopropyl alcohol or soapy water.
• • •
Missing some Tweet in this thread? You can try to
force a refresh
i printed a new panel insert that has two BNC sockets on it (the original probes would have had captive cables)
the tricky part is that this oscilloscope has a 333K ohm input impedance instead of 1M like umm every other scope on the planet. fortunately someone designed a little conversion circuit...
in honor of Sim Wong Hoo, here's a quick historical review of the Sound Blaster! 🧵
but first we have to go back to their first sound card, the Creative Music System from 1987. (image credit: Bratgoul on Wikipedia)
this card has some special "CMS-301" chips. if you peel back the sticker, they have had their top marks removed. they're actually SAA1099 synthesizer chips made by Philips. Creative wrote music composition software for musicians on the PC.