🧵regarding one of the most basic and commonly used instruments in surgery...the DeBakey forceps.

DeBakey forceps were designed for vascular and cardiac surgery, but now are used by almost everyone.
I'm surprised myself that we haven't covered it already.

So here goes...
1/
Michael DeBakey doesn't need much introduction: he was one of the most famous surgeons of all time. He was a pioneer in cardiothoracic and vascular surgery and was at Baylor for decades, eventually becoming chancellor. His rivalry with Denton Cooley was the stuff of legends.
DeBakey also was by all accounts very malignant, even when judged against old-school cardiac surgeons in Texas. And other behaviors were problematic. He wouldn't last 24 hr at a US hospital today.
He leaves a large but complex legacy that everyone has their own opinion about.
'DeBakey forceps' were initially custom made for DeBakey himself by the George Pilling & Son Company in Philadelphia. This is the earliest version of the ad I can find, and is from 1960.

The site of the Pilling offices later became the Franklin Building on the Penn campus.
Like most forceps, DeBakeys have a series of ridges on the side to enhance the grip.

This is a modification going back many centuries, as can be seen from the drawing of forceps with similar ridges from the ancient Roman era (R picture, forcep 'G'; from Kirkup's book).
Nor is the general size and profile of the DeBakey forceps anything new.
Forcep 2 on the R picture (also from the Kirkup book) is from the Roman era also. It is remarkably similar to modern DeBakey forceps.
One end of the DeBakey forceps has a single row of teeth. If you look carefully, it also has 2 small grooves (red arrows) which will accommodate the 2 rows of teeth on the other prong of the forcep.
And as you might expect, the other prong has the opposite configuration.

Here there are two rows of teeth, and also a groove to accommodate the single row of teeth from the other prong.
The teeth and grooves fit together with precision, but one sees that they do not do this along the entire length of the row of teeth. There is a little gap present proximally (R photo). The gap closes with a little pressure (not shown).
The small interlocking ridges on the tips of the DeBakey forceps enable you to grab and manipulate needles fairly easily.
It is much harder to do this with forceps without the ridges, such as with 'rat-tooth' forceps on the right.
Example showing the ease of grabbing small needles (5-0 Vicryl on PS-2 here). One can readily manipulate the needle to grab it with the needle holder.

There are limits to this. You want to follow the curvature of the needle and so forth...surgeons often get sloppy here.
One should try to avoid grabbing the actual suture threads though.
In 1989, Dobrin wrote that grasping small Prolene sutures (6-0) with DeBakeys caused them to weaken in a dose dependent fashion.
Grasping the threads with forceps weakened them than most other common maneuvers.
DeBakey forceps can be used to grab many different kinds of tissue, not just vessels. They are precise, tend to grab tissues reasonably well due to the ridges, and tend not to crush the tissue too much, unless one is not careful.
One still needs to keep tissue crushing in mind though, as some can occur with DeBakeys.

Here are 'during' and 'after' pictures of chicken meat grasped for about 15 seconds with a DeBakey at a typical pressure. One can see there are marks left over.
Here are the same 'during' and 'after' pictures, except with toothed Adson forceps.

In some cases toothed forceps may be better for the tissues due to the decreased pressure one has to apply on the tips of the forceps. This is a complicated topic for another day, however...🧐🤔
DeBakey forceps come in different lengths. As they get longer, the tips start having a weaker grip becasue they are still generally of about the same size.

This is a 12" DeBakey. The grip is noticeably weaker, and deforms more easily when picking up objects.
Reference:

As before, chicken thighs were sourced from Draper Valley Farms via QFC market in Beaverton, OR. Accessed December 3, 2022.

The study was conducted under an EFIC (Exception from Informed Chicken) protocol.
⬛️

• • •

Missing some Tweet in this thread? You can try to force a refresh
 

Keep Current with Ron Barbosa MD FACS

Ron Barbosa MD FACS Profile picture

Stay in touch and get notified when new unrolls are available from this author!

Read all threads

This Thread may be Removed Anytime!

PDF

Twitter may remove this content at anytime! Save it as PDF for later use!

Try unrolling a thread yourself!

how to unroll video
  1. Follow @ThreadReaderApp to mention us!

  2. From a Twitter thread mention us with a keyword "unroll"
@threadreaderapp unroll

Practice here first or read more on our help page!

More from @rbarbosa91

Dec 2
Getting one of those AI text generators…may not have been a good idea for me. 😬

Here I ask the Dall-E machine a few questions… Image
The AI machine is a bit wishy washy about this question… Image
I think we all knew this would be true, so I’ll give the AI algorithm some points here… Image
Read 6 tweets
Nov 28
Today's short 🧵 is on the Hoffman clamp, a device that may only be of interest to a few of you...

But I picked it because I enjoy pointing out when simple devices play a key role in complex situations.

Here, we see a Hoffman clamp restricting flow in an ECMO circuit.
(1/ ) ImageImage
... but why would you ever want to use a clamp to partially occlude the tubing, you ask??

After all, the ECMO machine has a knob that controls flow, does it not? Can't you just turn the knob to dial the flow down? 🤔 Image
But it's different for more complex circuits.

This patient is on VAV ECMO. The drainage cannula is in the femoral vein...but now there are 2 'return' cannulas...one in the femoral artery and also one in the RIJ vein. They are joined by a Y connector. The circuit is 'VAV'. Image
Read 8 tweets
Nov 23
🧵of 🧵
We've done several sutures already, now it's time to cover Vicryl (polyglactin 910).

Vicryl is the Ford truck of sutures: it's strong, familiar to everyone, and easy to use. A true workhorse. But it breaks down earlier than others.
We'll go over the usual... (1/ ) Image
Vicryl came out in 1974 as one of the first synthetic absorbable sutures. A coating was added in 1979, which improved its handling characteristics.
Today, it is one of the world's most commonly used sutures. It may be either undyed or a violet color. ImageImage
'Polyglycolic acid' sutures (Polysorb, Dexon) are made from a polymer of glycolic acid.
whereas:
'Polyglactin 910' (Vicryl) also adds lactide into the polymer, which makes it stronger. The result is that polyglactin 910 is a little stronger, but it breaks down at the same rate. Image
Read 16 tweets
Nov 14
🧵on the spoon as a surgical instrument.
(inspired by a post by @SKhalilMD and its replies)

By this I don't mean curettes or spoon-like instruments...I literally mean an actual kitchen spoon, as it has been used during real surgical operations. Image
Intuitively, a spoon *should* be a useful tool:

It has a wide, atraumatic surface for general retraction, and also a curved portion that fits the curvature of needles while protecting the underlying tissue.
Also, most people have already had decades of experience handling them. Image
This is the spoon from our cardiac surgery tray. Here you can clearly see that the mashed potatoes are well protected from being damaged by the suture needle.

(homemade; potatoes from Market of Choice, Beaverton OR, accessed 11/13/2022; with permission). Image
Read 12 tweets
Nov 1
🧵regarding the principles of 'traction' and 'countertraction'.

These are critical skills that you must master if you expect to become technically proficient in a surgical specialty. Image
First, some terminology.
"Retraction" is when one pulls on tissue to expose an area. Here, a retractor is used to expose the carotid.
But aside from allowing us to see it, the retractor is not doing anything to help us dissect it out. It is not providing 'traction' per se. Image
When we say 'traction', it usually means that we are pulling directly on the structure of interest, or something directly connected to it.
Here, the surgeon is applying 'traction' to the colon to help place tension on the ligaments so as to help mobilize the splenic flexure. Image
Read 19 tweets
Oct 14
🧵of 🧵
We've covered several sutures now. Next is Monocryl (or poliglecaprone 25).

It was designed for skin and subcutaneous tissues, and is still used mostly for that, but is also used in a number of other settings.
We will go over properties, uses, etc (the usual things...)
Monocryl suture came out in 1993. It is a monofilament, absorbable suture made of 2 'copolymers'. I'll skip the chemical detail, but one of the polymers is strong and the other is flexible, so the suture is meant to be…well…strong and flexible 🧐.
In terms of strength, Monocryl suture seems to be:

-stronger than silk
-similar to PDS
-a little weaker than Vicryl
The strength is short-lasting: it has significantly degraded by 2 wk and is gone by 3 wk. So it lasts longer than chromic, but not as long as those others.
Read 15 tweets

Did Thread Reader help you today?

Support us! We are indie developers!


This site is made by just two indie developers on a laptop doing marketing, support and development! Read more about the story.

Become a Premium Member ($3/month or $30/year) and get exclusive features!

Become Premium

Don't want to be a Premium member but still want to support us?

Make a small donation by buying us coffee ($5) or help with server cost ($10)

Donate via Paypal

Or Donate anonymously using crypto!

Ethereum

0xfe58350B80634f60Fa6Dc149a72b4DFbc17D341E copy

Bitcoin

3ATGMxNzCUFzxpMCHL5sWSt4DVtS8UqXpi copy

Thank you for your support!

Follow Us on Twitter!

:(