DanielR Profile picture
Sep 5 13 tweets 5 min read Read on X
1. A russian soldier surrenders to a #Ukrainian #drone by offering a trade. What is this thing that the russian is offering in exchange for his life? Is this a fair exchange? Image
2. Here is a better view of the case. It is a russian Thunderstorm electronic warfare system intended to combat drones. The controls are very simple. There are two power switches to enable the transmitters. There is also a switch & indicator for checking the battery voltage. Image
3. Removing the lid from the battery compartment reveals the underside of the controls. The battery-level board is not protected. This lid is held in place with hardware-store brackets and pop rivets. Image
4. The battery-level indicator costs about US$2. It is not waterproof and probably won’t last long in a trench or on a tank. Image
5. The battery is held in place with a metal clamp, which will almost certainly wear through the plastic cover protecting battery. The result will be a nice fire. Also visible is an external connector for charging the battery. Image
6. There are 3 jammer modules inside the case. The modules are Chinese-made and cost about US$100 each. Each module is connected to an antenna via a coax cable. These modules typically generate a lot of heat. There is a fan but no vents in the case. Also, there is no fan guard. Image
7. Instead of using a heatsink, the modules have insulating asbestos cloth placed between them and the plastic case. This likely guarantees the modules will overheat and fail but not melt the case. Image
8. Each module sweeps through a certain frequency range & requires a matched antenna. There are 3 directional antennas that transmit 100 W RF into the operator’s groin. The 2.4 GHz & 1.5 GHz antennas must be pointed at the drone to interfere with the control & GPS signals. Image
9. The 5.8 GHz helix antenna is odd as this type is directional and normally used for video receivers. To be effective, this antenna would need to be aimed at the ground station (pilot), not towards the drone. The polarisation would need to be correct too. Seems sketchy. Image
10. A question for the antenna experts. The two Yagi disc antennas look identical but operate at different frequencies. Does this seem reasonable or would different designs or sizes be expected? Note the serial number: they are making lots of these. Image
11. The instructions are an interesting read and state that the Thunderstorm will overheat and stop working when used as intended. It also warns against getting it hot, cold, wet or otherwise turning it on. Image
12. Overall it looks dodgy and perhaps someone in russia is making lots of money (it sells for about US$2,200). I have no idea how well the soldier in #1 fared but here is a photo of happy (?) russians receiving new ones. Note that there are a few variations of this design. Image
13. There are many examples of poor-quality electronic warfare kit, probably because the soldiers don’t know any better. If you found this thread interesting, please repost as a quote. Respectful comments are always welcome. Also consider reading my previous threads listed under “Highlights”.Image

• • •

Missing some Tweet in this thread? You can try to force a refresh
 

Keep Current with DanielR

DanielR Profile picture

Stay in touch and get notified when new unrolls are available from this author!

Read all threads

This Thread may be Removed Anytime!

PDF

Twitter may remove this content at anytime! Save it as PDF for later use!

Try unrolling a thread yourself!

how to unroll video
  1. Follow @ThreadReaderApp to mention us!

  2. From a Twitter thread mention us with a keyword "unroll"
@threadreaderapp unroll

Practice here first or read more on our help page!

More from @DanielR33187703

Aug 30
1. Ukraine announced that it had tested a long-range “rocket drone” called Palianytsia. Is this weapon, in practice, a cruise missile? This thread is a closer look at this (likely important) weapon. Image
2. Other than a few simple sketches & animations, Ukraine has released very few details about Palianytsia. The approach used here was to carefully study this public information with the aim of making a CAD drawing. From this drawing, various design aspects are considered. Image
3. How big is Palianytsia? If it uses an AI-PBS-350 turbojet engine, which is a joint project between PBS (Czech Republic) and Ivchenko-Progress (Ukraine), then the size is easily estimated. This engine weighs 51 kg with a maximum thrust of 3,400 N. Image
Read 15 tweets
Aug 20
1. Is it secret or not a secret? I have posted many threads detailing the technical aspects of #Ukrainian and russian #drones, including quadcopters and fixed-wing aircraft. Is any of this information secret? Image
2. There are always a few, possibly well-meaning, commenters who think my threads reveal secrets that will benefit the russians. Shown are a few select comments. Do they have a point or are they just technically uniformed? Let’s have a closer look at not-a-secret drones. Image
3. Amateurs started building radio-controlled (RC) aircraft more than 60 years ago. It was about 50 years ago that RC planes, although very expensive, became popular. This is relevant because all low-cost drones in Ukraine use hobby-grade components, which are not secret. Image
Read 22 tweets
Aug 16
1. Recently, a very interesting #Ukrainian precision-guided munition was captured by russians. This is a closer look at this (possibly important) weapon.
t.me/vanguard_space…
Image
2. This munition was captured by russians who posted 2 photographs of a crashed Ukrainian Baba Yaga drone along with. Also shown was an interesting munition that had been damaged in the crash. By carefully studying these 2 photos, a drawing was made. Image
3. This is the resulting CAD drawing produced (by me). Note that this drawing is only an approximation and some details are omitted. Overall length was estimated as roughly 52 cm and diameter as 10 cm. Conceptually, it has the three main sections shown here. Image
Read 11 tweets
Aug 2
1. A very large #Ukrainian Baba Yaga #drone was captured by the russians. Other than its size there are a number of very interesting details.
t.me/vanguard_space…
Image
2. The drone lost one of its arms and heavily hit the ground bending its frame. It is very nicely made and was probably expensive. There are 4 antennas for radio control making this drone difficult to defeat with electronic warfare. Image
3. This drone’s munitions are extremely interesting. These are optically (laser) guided. Baba Yaga drones are large and fly slow, making them very easy targets to shoot down with small arms. Guided munitions would enable bombing from much higher altitudes. Image
Read 6 tweets
Jul 17
1. The air data computer from a Shahed-136 #drone was reversed engineered by Le labo de Michel @lelabodemichel5162 with a detailed explanation given in a YouTube video. This computer supplies airspeed and altitude to the drone’s flight computer. Image
2. The circuit board is fairly small and has two air pressure transducers. One transducer is used for measuring altitude and the other is for airspeed. The board transmits data over an old-school RS232 serial line. A JTAG port is for programming a microcontroller. Image
3. The pressure transducers appear to be from the Slovenian company, HYB Sensor. It is difficult to determine the exact models but possibly HPSD 3100 or HPSD 3000. Feel free to ask HYB Sensor if (and why) their products are in these drones. Image
Read 10 tweets
Jul 4
1. A single photo of a russian workbench gives a sense of how the #war is going for them. Here a russian Telegram channel proudly describes the “FPV "OFFICE" of their graduate. Let’s have a closer look.
t.me/FPV_vyZOV/1673
Image
2. There are a few things including the rifle (AK?) indicating this is near the frontlines. Can weapons folks please comment on this rifle, especially if there is anything interesting about it? Image
3. The munition looks like a nasty thermobaric warhead that is used against vehicles and personnel. It seems odd to have this on a workbench meant for repairing drones. Image
Read 17 tweets

Did Thread Reader help you today?

Support us! We are indie developers!


This site is made by just two indie developers on a laptop doing marketing, support and development! Read more about the story.

Become a Premium Member ($3/month or $30/year) and get exclusive features!

Become Premium

Don't want to be a Premium member but still want to support us?

Make a small donation by buying us coffee ($5) or help with server cost ($10)

Donate via Paypal

Or Donate anonymously using crypto!

Ethereum

0xfe58350B80634f60Fa6Dc149a72b4DFbc17D341E copy

Bitcoin

3ATGMxNzCUFzxpMCHL5sWSt4DVtS8UqXpi copy

Thank you for your support!

Follow Us!

:(