Thank you @armbian & @Swisscom
This is a screenshot of me using an iOS VNC client on a fresh #armbian install on a OrangePi One Plus via VPN set up on the Swisscom router.
Took me about an hour to get it installed and set up.
This is a screenshot of me using an iOS VNC client on a fresh #armbian install on a OrangePi One Plus via VPN set up on the Swisscom router.
Took me about an hour to get it installed and set up.
There‘s more to this that I‘m not going to disclose, just one hint: @pfsense may be involved too.
I also got all my new stepper cables (new? Yes, replacing all of them with shielded ones and grounding my printer) tested today. Making them took me an afternoon 😅
Next step will be finalising the OPi and Klipper3D, then commissioning the hardware (new direct extruder w/ pancake stepper motor and MicroSwiss linear rail mod), configuring the TMC stepper drivers and hopefully not crashing the three axis 🙈
• • •
Missing some Tweet in this thread? You can try to
force a refresh
